Rki-instruments 35-3001-01-03 Uživatelský manuál

www.rkiinstruments.com35-3001-01-03Methane Sample-Draw DetectorOperator’s ManualPart Number: 71-0301RKRevision: P6Released: 9/17/14

6 • 35-3001-01-03 Methane Sample-Draw DetectorInstallationThis section describes procedures to mount the sample-draw detector in the monitoring envir

35-3001-01-03 Methane Sample-Draw Detector • 72. Close and latch the housing door.NOTE: The sample-draw detector is shipped with the mounting feet “

8 • 35-3001-01-03 Methane Sample-Draw Detectorring, if it came out, in the orientation shown in Figure 4. 4. Screw the inlet fitting tube nut back on

35-3001-01-03 Methane Sample-Draw Detector • 9Installing the Exhaust Line1. Loosen the nut on the exhaust fitting until 3 threads are visible.2. Pus

10 • 35-3001-01-03 Methane Sample-Draw Detector8. Connect the wires to the applicable detector/transmitter terminal strip at the controller as shown

35-3001-01-03 Methane Sample-Draw Detector • 11Start UpThis section describes procedures to start up the sample-draw detector and place the sample-d

12 • 35-3001-01-03 Methane Sample-Draw DetectorMaintenanceThis section describes maintenance procedures. It includes preventive maintenance procedure

35-3001-01-03 Methane Sample-Draw Detector • 135. Store the calibration kit in a safe place.Biannual CalibrationCalibrate the sample-draw detector a

14 • 35-3001-01-03 Methane Sample-Draw DetectorRecommended action1. Verify that the calibration cylinder contains an adequate supply of a fresh test

35-3001-01-03 Methane Sample-Draw Detector • 153. Install the new particle filter onto the inlet fitting’s tubing stub. Be sure the arrow on the par

35-3001-01-03 Methane Sample-Draw DetectorWARNINGRead and understand this instruction manual before operating detector. Improper use of the detector

16 • 35-3001-01-03 Methane Sample-Draw DetectorCalibrationThis section describes how to calibrate the methane sample-draw detector. It includes proce

35-3001-01-03 Methane Sample-Draw Detector • 17Parts ListTable 2 lists replacement parts and accessories for the methane sample-draw detector.Table

35-3001-01-03 Methane Sample-Draw DetectorProduct WarrantyRKI Instruments, Inc. warrants gas alarm equipment sold by us to be free from defects in m

35-3001-01-03 Methane Sample-Draw DetectorTable of ContentsOverview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

35-3001-01-03 Methane Sample-Draw Detector • 1OverviewThis operator’s manual describes the 35-3001-01-03 methane sample-draw detector. This manual a

2 • 35-3001-01-03 Methane Sample-Draw DetectorDescriptionThis section describes the components of the methane sample-draw detector. Figure 1: Metha

35-3001-01-03 Methane Sample-Draw Detector • 3installation where general purpose equipment is in use.The housing door is hinged on the left side and

4 • 35-3001-01-03 Methane Sample-Draw DetectorDetector/Amp Terminal StripThe detector/amp terminal strip is the upper twelve-point terminal strip in

35-3001-01-03 Methane Sample-Draw Detector • 5door. The green Pilot LED is on when the sample-draw detector is receiving power from the controller.